Vapor Blasting

Before and After Vapor Blasting

Vapor blasting, sometimes called wet blasting or liquid honing, is rapidly becoming the go to service for applications that require a high quality surface finish.

Mid Valley Industrial Services uses the vapor blasting process to simultaneously degrease and blast away industrial components.

The key to vapor blasting is that the finish is produced through flow of water borne abrasive, giving a finer finish due to the flushing action of the water. No media is impregnated into the component, nor is there any dust created by the break-up of media, unlike dry blasting where the finish is produced by sheer force of media impact.

A specially designed glandless polyurethane pump agitates water and media into a slurry, which is contained within the cabinet sump. Delivery of the slurry to the manual blast nozzle is via a glandless polyurethane pump and associated hoses located inside the machine. The slurry is pumped at approximately 2 bar to the nozzle, and compressed air is introduced at the blast nozzle to accelerate the slurry and provide the cleaning effect on impact, albeit cushioned.

After contact with the component the slurry then drains back into the sump creating a re-circulating system. Fine broken down media and other contaminants are fed via an overflow to a sedimentation filter located at the rear of the cabinet.

The illustrations below show the different natures of grit, bead, and vapor blasting.


The aggressiveness of dry grit and bead blasting are shown in the first two illustrations which demonstrate the severe 90° ricochet that occurs when using these methods.

The third illustration shows the gentler, but just as effective, vapor blasting method. The ricochet of media is reduced due to the cushioning from the water; the angle of the media is changed producing a lapping effect travelling across the surface, giving an even satin/polished finish.

Advantages of Vapor Blasting:

Typical Applications: